Retail centers, office lobbies, restaurants, and other commercial properties decorate for the season, and decorations often mean extra power: light strings, illuminated displays, and signs. Much of it ends up using extension cords and power strips.
This guide covers general safety practices for property managers and tenants. Requirements come from electrical, fire, and occupational safety rules and vary by building and jurisdiction, so confirm them locally and use a licensed electrician for permanent wiring.

Temporary Does Not Mean Exempt
Cords and power strips used for decorations are subject to the same basic safety expectations as other equipment. OSHA, for example, addresses flexible cords and cables and says they should not be used as a substitute for fixed wiring. Fire codes also limit how temporary power can be used in public spaces. Check with your local fire marshal if you are unsure.
Plan Where Power Is Needed
Walk the space and decide where displays will go, then see where outlets are located. If displays need power far from outlets, a contractor can discuss adding outlets, which is safer than long cords. For exterior displays, outlets should be weather protected and ground-fault protected.
- Map which circuits feed each area, so that you do not overload one.
- Use cords rated for the load and for the location.
- Do not run cords through walls, ceilings, or under rugs where heat can build up.
- Keep cords out of walkways, or cover them with products made for the purpose.
Fire Safety and Egress
Decorations should not block exits, exit signs, fire alarm devices, or sprinklers. Use materials that are flame-resistant where required, and keep decorations away from heat sources and lighting that runs hot. Keep paths clear for people with mobility devices.
Ask your insurer and local fire officials about any requirements for natural trees and decorations in commercial spaces.
Tenants and Vendors
In multi-tenant properties, set expectations early. Share guidelines on decorations and power, ask tenants to notify you about large displays, and ask vendors who install displays to provide information on their equipment and power needs. A short written policy helps avoid surprises.
Inspect Before and After
Before the season, inspect existing lights and cords, and remove damaged ones. During the season, check regularly for warm cords, loose plugs, or tripped breakers. After the season, remove temporary wiring promptly and store decorations where they will not be damaged.
Plan for Next Year
If your property relies on temporary power each year, it may make sense to add permanent outlets, timers, or dedicated circuits for seasonal use. A contractor can design this so that it works for decorations and for other uses throughout the year. Our commercial electrical services and electrical construction services pages describe our work.
Keep a Contact List
List who to call if a breaker trips or a display fails, including your electrician, the building engineer, and a facilities contact. Post it where staff can find it. See our Safety and OSHA page for how we approach safety on the job.
Documentation for Insurance and Safety
Keep a note of any temporary power arrangements, such as where displays were plugged in, who installed them, and what was done to protect cords. If there is an incident, that information helps. Keep copies of vendor contact information and the product details for any large display that is wired in.
For owners with multiple sites, a standard checklist helps each property manager apply the same practices.
Weather Matters for Exterior Displays
Exterior displays at shopping areas face rain, wind, and cold. Check that connections are enclosed and weather protected, that fixtures are rated for wet locations, and that ground-fault protection is working. After storms, walk the displays and look for loose cords, water in enclosures, and tripped protective devices.
Talk With a Licensed Electrician
Planning holiday displays for a commercial property? A licensed electrician can review power needs and add outlets or circuits where they will help.
To discuss your project, visit our contact page or call McDaniel Electrical Construction at (410) 303-8453.
